Warning: Safety Precautions
IMPORTANT: Read these operating instructions carefully and com- pletely before trying to operate or service this tool. Improper use of this tool can cause serious injury or death from firing fastener into body or from flying debris. We expressly disclaim any liability for any injury to persons or damage to property which result from your failure to take the precautions contained in this manual.
WARNING: This tool is designed only for use by qualified operators. Qualification is obtained through a thorough understanding of the Safety Warnings and operating instructions as defined in this operating manual. NOTE: Your local labor regulations may require that the operator of this tool on a job site be thoroughly trained and certified for competence prior to operating this tool. For certification procedures, call:
BEFORE USING
? ? 
1.Always handle the tool as if it were loaded. Before starting work, check that the tool is unloaded and the muzzle is clear. Never load a tool unless it is going to be used.
2.Always inspect to make sure the tool is working properly. If the tool does not work properly, remove from service and tag “DEFECTIVE.” Do not use the tool again until it has been properly repaired.
3.Operators and bystanders must wear goggles and ear protection which meet or exceed the accepted standards for adequate protection in your country. In the U.S.A., refer to ANSI standards. In Canada, refer to CSA standards.
103500 | 3 |