OPERATION
WARNING:
If any parts are missing, do not operate tool until the missing parts are replaced. Failure to do so could result in possible serious personal injury.
SWITCH
See Figure 4.
Your drill starts and stops by depressing and releasing the switch trigger. Release the switch trigger to turn drill OFF.
VARIABLE SPEED
See Figure 4.
Your drill has a variable speed feature in the switch. The switch delivers higher speed and torque with increased trigger pressure. Speed is controlled by the amount of switch trigger depression.
SWITCH LOCK
See Figure 4.
The switch trigger can be locked in the OFF position. This feature helps reduce the possibility of accidental starting when not in use. To lock the switch trigger, place the direction of rotation selector in the center position.
REVERSIBLE
See Figure 4.
This tool is reversible. The direction of rotation is controlled by a direction of location selector located above the switch trigger. With the drill held in normal operating position, the direction of rotation selector should be positioned to the left of the switch for drilling. The drilling direction is reversed when the selector is to the right of the switch. When the selector is in center position, the switch trigger is locked.
CAUTION:
To prevent gear damage, always allow chuck to come to a complete stop before changing the direction of rotation.
To stop, release switch trigger and allow the chuck to come to a complete stop.
WARNING:
Battery tools are always in operating condition. Therefore, switch should always be locked when not in use or when carrying at your side.
DIRECTION OF | REVERSE |
ROTATION SELECTOR |
SWITCH
TRIGGER
22
16
CENTER POSITION
(LOCK)
FORWARD
Fig. 4
TWO SPEED
GEAR TRAINHI (2)
LO (1) SPEED
2
22 20
18 
16
Fig. 5
TWO SPEED GEAR TRAIN
See Figure 5.
Your drill has a
Page 8