OPERATION
TO INSTALL BATTERY PACK
■Place the direction of rotation selector in center posi- tion. See Figure 4.
■Place the battery pack in your drill. Align raised rib on battery pack with groove in drill's battery port. See Fig- ure 6.
■Make sure the latches on each side of your battery pack snap in place and that battery pack is secured in drill before beginning operation.
TO REMOVE BATTERY PACK
■Place the direction of rotation selector in center posi- tion. See Figure 4.
■Locate latches on side of battery pack and depress both sides to release battery pack from drill. See Figure 6.
■Remove battery pack from your drill.
CAUTION:
When placing battery pack in your drill, be sure raised rib on battery pack aligns with groove in drill's battery port and latches snap in place properly. Improper assembly of battery pack can cause damage to internal components.
KEYLESS CHUCK
See Figure 7.
A keyless chuck has been provided with your drill to allow for easy installation and removal of bits. As the name implies, you can hand tighten or release drill bits in the chuck jaws. Grasp and hold the collar of the chuck with one hand. Rotate the chuck body with your other hand. The arrows on the chuck indicate which direction to rotate the chuck body in order to GRIP (tighten) or RELEASE (unlock) the drill bit.
WARNING:
Do not hold chuck body with one hand and use power of the drill to tighten chuck jaws on drill bit. Chuck body could slip in your hand or your hand could slip and come in contact with rotating drill bit. This could cause an accident resulting in serious personal injury.
BATTERY
PACK
BATTERY
PORT
LATCHES
DEPRESS LATCHES TO |
|
RELEASE BATTERY PACK | Fig. 6 |
CHUCK
RELEASE COLLAR (UNLOCK)
22
20
18
6
GRIP
(TIGHTEN) CHUCK BODY
Fig. 7
Page 9