OPERATION
KNOW YOUR DRILL-DRIVER
See Figures 1 and 2.
Before attempting to use any tool, familiarize yourself with all operating features and safety requirements.
WARNING:
Do not allow familiarity with tools to make you careless. Remember that a careless fraction of a second is sufficient to inflict severe injury.
CHARGING YOUR DRILL-DRIVER
The battery pack for this tool has been shipped in a low charge condition to prevent possible problems. Therefore, you should charge it prior to use.
Note: Batteries will not reach full charge the first time they are charged. Allow several cycles (drilling followed by re- charging) for them to fully charge.
TO CHARGE
■Charge battery pack only with the charger provided.
■Make sure power supply is normal house voltage, 120 volts, 60 Hz, AC only.
■Connect charger to power supply.
■Place battery pack in charger. See Figure 3. Align raised rib on battery pack with groove in charger.
■Press down on battery pack to be sure contacts on battery pack engage properly with contacts in charger. When properly connected, red light will turn on.
■Normally, the yellow and green lights on the charger will come on. This indicates charger is in control charge mode and should switch to fast charge mode within 5 minutes. When charger is in fast charge mode the red light will come on. If after a period of 15 minutes the yellow and green lights remain on, remove the battery pack, wait 1 minute and
■When your battery pack becomes fully charged, the red light will turn off and the green light will turn on.
■After normal usage, 1 hour of charge time is required to be fully charged. A minimum charge time of 1 to
■The battery pack will become slightly warm to the touch while charging. This is normal and does not indicate a problem.
■DO NOT place charger in an area of extreme heat or cold. It will work best at normal room temperature.
TWO SPEED GEAR TRAIN
TORQUE |
|
ADJUSTMENT |
|
RING | 2 |
| BIT |
22 | STORAGE |
20 |
|
18 |
|
6 |
|
1 | DIRECTION OF |
| |
| ROTATION |
SWITCH | SELECTOR |
| |
KEYLESS TRIGGER |
|
CHUCK | WRIST |
| |
| STRAP |
BATTERY |
|
PACK |
|
| Fig. 1 |
GREEN LIGHT "ON" | BATTERY |
INDICATES FULLY | CHARGER |
CHARGED |
|
| RED LIGHT "ON" |
YELLOW AND GREEN LIGHTS "ON" | INDICATES FAST |
CHARGING MODE | |
INDICATES CONTROL CHARGE OR |
|
POSSIBLE FAULTY BATTERY | Fig. 2 |
| BATTERY |
| CHARGER |
BATTERY
PACK
Fig. 3
LED FUNCTION OF CHARGER
LED WILL BE LIGHTED TO INDICATE STATUS OF CHARGER AND BATTERY PACK:
1.Red LED lighted = Fast Charging Mode
2.Green LED lighted = Fully Charged Battery Pack
3.Yellow and Green LED Lighted = Control Charge or Defective Battery Pack.
Page 7