Ryobi TS1141 manual Tools Needed, Spindle Lock Button, Switch Trigger

Page 11

FEATURES

SPINDLE LOCK BUTTON

See Figure 3.

The spindle lock button locks the spindle stopping the blade from rotating. Depress and hold the lock button while installing, changing, or removing blade.

Switch

lock

SWITCH TRIGGER

See Figure 4.

The saw will not start until you depress the switch lock with your thumb then squeeze the switch trigger. To prevent unauthorized use of the compound miter saw, disconnect it from the power supply and lock the switch in the off position. To lock the switch, install a padlock (not included) through the hole in the switch trigger. A lock with a long shackle of 5/16 in. diameter may be used. When the lock is installed and locked, the switch is inoperable. Store the padlock key in another location.

Switch trigger

Padlock

Fig. 4

TOOLS NEEDED

The following tool (not included) is needed for making adjustments or installing the blade:

Square

Fig. 5

Image 11

Contents Save this Manual for Future Reference OPERATOR’S ManualIntroduction Table of ContentsRead ALL Instructions General Safety RulesPonent is in Contact with the Workpiece Specific Safety Rules Never Start a Tool When ANY ROTATiNG COM Specific Safety Rules Symbol Signal Meaning SymbolsElectrical Connection Cord Length Wire Size A.W.GElectrical Double InsulationGlossary of Terms Work Clamp FeaturesProduct Specifications Blade WrenchBlade Wrench Storage Know Your Compound Miter SAWAMP Motor Bevel Lock KnobSpindle Lock Button Switch TriggerTools Needed Miter saw Head Blade Rear bracket Carrying handle Dust BAGScrews Rear bracket Carrying handle AssemblyInstalling the rear bracket/carrying handle UnpackingBase Mounting the miter saw base to the standMounting Holes Unpacking Indicator Bevel ScrewAssembling the miter saw head to the base See Figures 10Work Clamp INSTALLing Batteries in LaserDust BAG To Leave Your Mark Aligning the laser guide lineRemoving Your Mark To Cut Your MarkSee Figures 16 To Install/replace the BladeSee Figures 18 Squaring the Miter Table to the FenceSee Figures 21 Squaring the Blade to the FenceSee Figures 25 Squaring the Blade to THE MITER TableSee Figures 29 OperationApplications To Cross cutSee Figures 31 IndicatorScaleSCREW indicator Bevel Cut Lock knob To Bevel CutCompound Miter Cut Work Clamp To Compound Miter CutSee Figures 33 Supports To Support Long Workpieces45 x 45 Compound Miter CUT Long WorkpiecePitch Number of Sides COMPOUND-ANGLE Settings for Popular StructuresCutting Compound Miters Right SIDE, Inside Corner Left SIDE, Outside Corner Cutting crown moldingLaying molding flat on the miter table Left SIDE, Inside Corner Right SIDE, Outside CornerWrong Cutting warped materialSee Figures 37 Bevel Pivot Adjustment AdjustmentsPositive Stop Adjustments Pivot Adjustments Travel Pivot AdjustmentLaser adjustment Screw Unlock Miter Lock Lever To Adjust the Laser GuideTo adjust the miter lock lever Lubrication MaintenanceGeneral Maintenance Brush ReplacementService Model NO. and Serial no