12 | WATER PUMP |
If Water Stops Flowing,
1.Stop Sawing, then
2.Disconnect Electrical Plug from Outlet, then
3.Remove the Pump, then
4.Back Flush.
Back flushing is done by forcing water into the pump discharge and out through the screen. Most of the time this procedure works, and the pump can be put back into service. (See Figure below)
If the back flushing does not work, remove the screen and turn the impeller manually, looking for and rinsing out the impeller cavity of any dirt or foreign matter.
13 
REPAIRS
We carry out all repairs in the shortest possible time and at the most economical prices. (See front page for. address and phone numbers) Contact your authorized Husqvarna® dealer concerning maintenance and re-
V-Belt Tensioning with Cam Adjustment:
Always set the Motor Switch to OFF and un- plug power cord before making any repairs or adjustments to your saw.
This tile saw is belt driven. The standard unit uses a 6 groove
if it is being replaced. Again, adjust only with the saw turned off and unplugged.
Tools needed: One 3/8” wrench, two 1/2” wrenches, one 3/8” Drive Extension x 8” or longer, and a 12” Straight Edge.
1.Remove the Belt Guard to get access to the
a.Remove two
b.Remove
2.Loosen the four
3.Remove the Belt Guard for full access to belt and pulleys.
a.Remove the two
from top of Guard.
b.Remove the
4.Rotate the belt tensioning Cam (1/2” Drive Extension) to tighten the belt(s) to proper tension.
d.WIth belt tensioned, use the 12” Straight Edge to check for correct pulley alignment and tighten the engine mounting screws.
e.Replace the Belt Guard before operating the. tile saw. Always replace any guarding before start-
14 
SPARE PARTS
For quick supply of spare parts and to avoid any lost time, it is essential to quote the data on the manufacturers plate fixed to the machine and the part number(s) and description to be replaced with every order.
16