| OPERATING | |
REAR HEX JAM | LEVER (#5) | |
CAP SCREW | ||
NUT (#10) | ||
FRONT HEX JAM | (#3) | |
NUT (#10) |
|
UPPER TONG
(#46)
|
| HEX NUT (#20) |
TONG |
|
|
TIP |
|
|
(#48) | LOWER TONG (#47) | FIGURE F |
|
To Use The Power Switch:
1.The Power Switch (part #25) allows electrical current to the Spot Welder to be turned “ON” and “OFF”. (See Figure D, and Assy. Diagram.)
2. | Turn the Power Switch (part #25) sideways in either direction to start the | electrical |
| current . Release the Power Switch to stop the electrical current. |
|
To Use The Operating Lever: |
| |
1. | Caution: Never touch the Upper and Lower Tongs (parts #46, #47) when weld- | |
| ing a workpiece. Allow the Tong Tips (part #48) and the workpiece to cool before han- | |
| dling. (See Figures A, B, E, and Assy. Diagram.) |
|
2.The Operating Lever (part #5) allows you to open and close the Upper and Lower Tongs (parts #46, #47). (See Figures A, F, and Assy. Diagram.)
3.Close the Operating Lever (part #5) during the welding process to compress the work-
pieces between the Tong Tips (part #48). Open the Operating Lever after the spark ap- pears and each weld is made to release the workpieces. (See Figures B, A, F, and
Assy. Diagram.)
SKU 45689 | For technical questions, please call | Page 9 |