NaviTrack® II
Activating Frequencies
Frequencies can be chosen for the set of
Each frequency is activated by choosing it from a list in the Main Menu (See Figure 15). Frequencies are grouped by category:
Sonde
Active Line Trace
Passive Line Trace (Power) 
1. Push the Menu Key:
Figure 14 – Menu Key
The Main Menu is then activated:
Figure 15 – Main Menu
2.Using the up and down arrows, highlight the fre- quency desired. In Figure 16, below, the operator is activating a 128 Hz frequency.
Figure 16 – Highlighting a Desired Frequency (128 Hz)
3.Press the Select Key (shown below) to check the box for each frequency intended for use.
Figure 17 – Select Key
Figure 18 – Desired Frequency Checked
4.Frequencies that have been selected for use will show a check in the box next to them. These are
5.Press the Menu Key again to accept the choices and exit. The last selected
Figure 19 – Menu Key
The Main Menu lists all frequencies currently available for activation. For information on adding additional frequen- cies to the Main Menu so they can be chosen for activa- tion, see “Frequencies Selection Control” on page 23. (European versions of the NaviTrack II include a 93 kHz Line Tracing frequency. See the note on page 17 on using this frequency.)
Ridge Tool Company | 11 |
