NaviTrack® II
In the final analysis there is one “most important” com- ponent in the locating task – the operator. The NaviTrack
IIgives an operator an unprecedented amount of infor- mation to be able to make the correct decision rapidly and accurately.
NaviTrack II Maintenance
Transportation and Storage
Before transporting make sure that the unit is turned off to preserve battery power.
When Transporting make sure that the unit is secure and does not bounce around or get bumped by loose equip- ment.
The NaviTrack II should be stored in a cool dry place.
NOTE! If storing the NaviTrack II for an extended period of time then the batteries should be removed.
If shipping the NaviTrack II, remove the batteries from unit.
Installing/Using Accessories
The NaviTrack II also comes with Sonde and Pole Markers that can be used to mark Pole or Sonde locations above ground. There are two (2) red markers to mark the Poles and one (1) yellow marker to mark the Sonde. The mark- ers can also be used to temporarily mark points to come back to while scouting a target area or tracing a line.
If further assistance is needed, please call:
RIDGE Tool Technical Service at
Maintenance and Cleaning
1.Keep the NaviTrack II clean with a damp cloth and some mild detergent. Do not immerse in water.
2.When cleaning, do not use scraping tools or abrasives as they may permanently scratch the display. NEVER USE SOLVENTS to clean any part of the system. Substances like acetone and other harsh chemicals can cause cracking of the case.
Locating Faulty Components
For troubleshooting suggestions, please refer to the
Service and Repair
WARNING
Instrument should be taken to a RIDGID Independent Authorized Service Center or returned to the factory. Remove batteries entirely before shipping. All repairs made by Ridge service facilities are warranted against de- fects in material and workmanship.
CAUTION Remove batteries entirely before shipping.
If you have any questions regarding the service or repair of this machine, call or write to:
Ridge Tool Company
Technical Service Department
400 Clark Street
Elyria, Ohio
Tel: (800)
For name and address of your nearest Independent Authorized Service Center, contact Ridge Tool Company at (800)
Ridge Tool Company | 29 |
