Hobart Welding Products OM-2210 manual Connecting Work Clamp And Gas/Air Supply

Page 18

3-7. Connecting Work Clamp And Gas/Air Supply

1

2

3

64

From Gas/Air Supply

5

Tools Needed: 5/8, 1-1/8 in

1Work Clamp

2Workpiece

Connect work clamp to a clean, paint-free location on workpiece, as close to cutting area as possible.

.Use only clean, dry air with 70 to 150 psi (483 to 1034 kPa) pressure.

3Air Filter/Regulator

4Gas/Air Inlet Opening

5Hose

6Teflon Tape

Obtain hose with 1/4 NPT right- hand thread fitting. Wrap threads with teflon tape (optional) or apply pipe sealant, and install fitting in opening. Route hose to gas/air supply.

Adjust gas/air pressure according to Section 4-1.

Ref. 801 319-C / Ref. 801 306-C

OM-2210 Page 14

Image 18

Contents OM-2210 ProcessesDescription From Hobart to You Table of Contents Directives StandardsPlasma Arc Cutting Hazards Symbol UsageMarks a special safety message Cutting can cause fire or explosionNoise can damage hearing Flying Sparks can cause injuryARC Rays can burn eyes and skin Fumes and Gases can be hazardousFlying Metal can injure eyes HOT Parts can cause severe burnsMoving Parts can cause injury Overuse can cause OverheatingPrincipal Safety Standards EMF InformationAbout Pacemakers UNE DÉ Charge É Lectrique peut entraîner la mort Signification des symbolesLE Coupage pré sente un risque de feu ou d’explosion Identifie un message de sé curité particulierLE Plasma D’ARC peut entraîner des blessures LE Bruit peut endommager l’ouïeLES Fumé ES ET LES GAZ peuvent ê tre dangereux LES Bouteilles peuvent exploser si elles sont endommagé esPrincipales normes de sé curité Information sur les champs é lectromagné tiques Consignes relatives aux stimulateurs cardiaquesDefinitions I1max Symbols And DefinitionsManufacturer’s Rating Label For CE Products I1effInstallation Specifications For CE ModelDuty Cycle And Overheating For CE Model Exceeding duty cycle can damage unit and void warrantyDuty Cycle And Overheating For Non-CE Model OverheatingDimensions And Weight Selecting a LocationConnecting Work Clamp And Gas/Air Supply Installing Alternative Plug Rear Of UnitSetting Gas/Air Pressure OperationControls Cutting Speed Sequence Of Operation Example Of Cutting OperationTrigger is pressed Maintenance & Troubleshooting MonthsWays turn Off power when changing or checking consumables Checking Torch Shield Cup Shutdown SystemTorch And Work Cable Connections Torch ConnectionsWork Cable Connections Troubleshooting Trouble RemedyElectrical Diagram Circuit Diagram For Power SourceParts List Main AssemblyDia Part Mkgs Description Quantity +181 Service SupportContact your Distributor for Hobart Welding Products