Hobart Welding Products OM-2210 manual Torch And Work Cable Connections, Torch Connections

Page 25

5-3. Torch And Work Cable Connections

8

9

2

5

11

613

7

10

3

1

4

12

Tools Needed:

5/8 in

If torch or work cable needs to be removed or replaced, proceed as follows:

Turn power Off, and disconnect in- put power plug from receptacle. Re- move top and screws holding front panel in place. Without disconnect- ing any plugs, move front panel to allow access.

Torch Connections

1Strain Relief Clamp

2Torch Cable

Insert cable through strain relief clamp.

3Gas Connector

4Gas Valve

Install gas connector onto gas valve.

5Plug PLG18

6Safety Control Board PC2

7Receptacle RC18

Connect PLG18 to RC18. Route leads along existing lead bundle.

8Female Friction Terminals

9Male Friction Terminal

10Power Control Board PC1

11Receptacle RC4

Connect female terminals to leads 23 and 24 from RC4 (connect to either lead). Connect male terminal to lead 25 from RC4. Route leads as shown.

Work Cable Connections

12 Strain Relief Clamp

Insert work clamp lead through strain relief clamp.

13 Receptacle RC6

Connect work clamp lead to lead 20 from RC6 (leads not shown). Route leads along existing lead bundle.

801 423-A / Ref. 801 300-B

OM-2210 Page 21

Image 25

Contents Processes OM-2210Description From Hobart to You Table of Contents Standards DirectivesMarks a special safety message Symbol UsagePlasma Arc Cutting Hazards Cutting can cause fire or explosionARC Rays can burn eyes and skin Flying Sparks can cause injuryNoise can damage hearing Fumes and Gases can be hazardousMoving Parts can cause injury HOT Parts can cause severe burnsFlying Metal can injure eyes Overuse can cause OverheatingEMF Information Principal Safety StandardsAbout Pacemakers LE Coupage pré sente un risque de feu ou d’explosion Signification des symbolesUNE DÉ Charge É Lectrique peut entraîner la mort Identifie un message de sé curité particulierLES Fumé ES ET LES GAZ peuvent ê tre dangereux LE Bruit peut endommager l’ouïeLE Plasma D’ARC peut entraîner des blessures LES Bouteilles peuvent exploser si elles sont endommagé esPrincipales normes de sé curité Consignes relatives aux stimulateurs cardiaques Information sur les champs é lectromagné tiquesDefinitions Manufacturer’s Rating Label For CE Products Symbols And DefinitionsI1max I1effSpecifications For CE Model InstallationDuty Cycle And Overheating For Non-CE Model Exceeding duty cycle can damage unit and void warrantyDuty Cycle And Overheating For CE Model OverheatingSelecting a Location Dimensions And WeightConnecting Work Clamp And Gas/Air Supply Rear Of Unit Installing Alternative PlugOperation Setting Gas/Air PressureControls Cutting Speed Example Of Cutting Operation Sequence Of OperationTrigger is pressed Months Maintenance & TroubleshootingChecking Torch Shield Cup Shutdown System Ways turn Off power when changing or checking consumablesTorch Connections Torch And Work Cable ConnectionsWork Cable Connections Trouble Remedy TroubleshootingCircuit Diagram For Power Source Electrical DiagramMain Assembly Parts ListDia Part Mkgs Description Quantity +181 Support ServiceHobart Welding Products Contact your Distributor for