Hobart Welding Products OM-2210 manual Directives, Standards

Page 4

Declaration of Conformity for

European Community (CE) Products

NOTE

This information is provided for units with CE certification (see rating label on unit).

Declares that the product: AirForce 375

conforms to the following Directives and Standards:

Directives

Electromagnetic Compatibility Directives: 89/336/EEC, 92/31/EEC

Low Voltage Directive: 73/23/EEC

Machinery Directives: 89/392/EEC, 91/368/EEC, 93/C 133/04, 93/68/EEC

Standards

Electromagnetic compatibility (EMC) Product standard for arc welding equipment:

EN50199: August 1995

Safety Requirements for Arc Welding Equipment part 1: EN 60974-1: 1989

Arc Welding Equipment Part 1: Welding Power Sources: IEC 974-1

(April 1995 – Draft revision)

Degrees of Protection provided by Enclosures (IP code): IEC 529: 1989

Manufacturer’s Name: Miller Electric Mfg. Co.

Manufacturer’s Address: 1635 W. Spencer Street, Appleton, WI 54914 USA

European Contact: Mr. Luigi Vacchini, Managing Director

MILLER Europe S.P.A.

Via Privata Iseo

20098 San Giuliano

Milanese, Italy

Telephone: 39(02)98290-1

Fax: 39(02)98281-552

dec_con1 1/96

Image 4

Contents Processes OM-2210Description From Hobart to You Table of Contents Directives StandardsSymbol Usage Marks a special safety messagePlasma Arc Cutting Hazards Cutting can cause fire or explosionFlying Sparks can cause injury ARC Rays can burn eyes and skinNoise can damage hearing Fumes and Gases can be hazardousHOT Parts can cause severe burns Moving Parts can cause injuryFlying Metal can injure eyes Overuse can cause OverheatingEMF Information Principal Safety StandardsAbout Pacemakers Signification des symboles LE Coupage pré sente un risque de feu ou d’explosionUNE DÉ Charge É Lectrique peut entraîner la mort Identifie un message de sé curité particulierLE Bruit peut endommager l’ouïe LES Fumé ES ET LES GAZ peuvent ê tre dangereuxLE Plasma D’ARC peut entraîner des blessures LES Bouteilles peuvent exploser si elles sont endommagé esPrincipales normes de sé curité Information sur les champs é lectromagné tiques Consignes relatives aux stimulateurs cardiaquesDefinitions Symbols And Definitions Manufacturer’s Rating Label For CE ProductsI1max I1effInstallation Specifications For CE ModelExceeding duty cycle can damage unit and void warranty Duty Cycle And Overheating For Non-CE ModelDuty Cycle And Overheating For CE Model OverheatingDimensions And Weight Selecting a LocationConnecting Work Clamp And Gas/Air Supply Installing Alternative Plug Rear Of UnitOperation Setting Gas/Air PressureControls Cutting Speed Example Of Cutting Operation Sequence Of OperationTrigger is pressed Maintenance & Troubleshooting MonthsWays turn Off power when changing or checking consumables Checking Torch Shield Cup Shutdown SystemTorch Connections Torch And Work Cable ConnectionsWork Cable Connections Troubleshooting Trouble RemedyElectrical Diagram Circuit Diagram For Power SourceParts List Main AssemblyDia Part Mkgs Description Quantity +181 Service SupportContact your Distributor for Hobart Welding Products