Hobart Welding Products OM-928 Connecting Work Clamp Connecting Input Power, Work Clamp Workpiece

2-6. Connecting Work Clamp

1

2

2-7. Connecting Input Power

1 Work Clamp

2 Workpiece

Connect work clamp to a clean, paint-free location on workpiece, as close to cutting area as possible.

802 463-A

2

1

Check input voltage available at site.

1 Grounded Receptacle

A 120 volt, 20 ampere individual branch circuit protected by time-delay fuses or circuit breaker is required (see Section 2-1).

2 Plug From Unit

Select extension cord of 12 AWG for up to 75 ft (23 m) or 10 AWG for up to 140 ft (46 m).

YSpecial installation may be required where gasoline or volatile liquids are present – see NEC Article 511 or CEC Section 20.

802 589-A

OM-928 Page 11