Chapter 5 Unix Troubleshooting Tips

ETHERNET, WIRELESS

10.Power the printer off and then back on.

11.Set the IP address, subnet mask, and default gateway parameters to the desired values.

12.If the Web browser access does not work, telnet into the Ethernet Interface as root. Enter the following command:

config http on

To reset all Integrated Ethernet Interface TCP/IP values to the factory defaults when access is impossible, contact your IBM service representative for assistance.

Front Panel Message - Dynamically Set Params Read Only

This is not an error. It is an informational message warning that the IP address has been dynamically set by dhcp, rarp, or bootp.

To assign a static IP address, turn off the rarp, bootp, and dhcp on the adapter. Use the following procedure:

1.Telnet to the adapter. Login = root, password = (Enter key) Telnet commands are:

store tcpip 1 opts -rarp -bootp -dhcp

reset

Wait two minutes for the adapter to reset.

2.Program the IP address, Subnet Mask, and Gateway (if required) from the front panel.

172

Page 172
Image 172
IBM 6500 manual Front Panel Message Dynamically Set Params Read Only, ETHERNET, Wireless