IBM 6500 manual Setting Up a TN5250 Connection/Device Via a Telnet Session

Chapter 12 Setting Up A TN5250 Connection/Device Via A Telnet Session

NOTE: It is not necessary to set up the devd or queue name on the iSeries manually or in advance. The configuration and reset of the Ethernet adapter automatically sets up the devd or queue name.

Setting Up A TN5250 Connection/Device Via A Telnet Session

In a telnet session, the command “list tn” shows the configured values. To set up a TN5250 connection/device via a telnet session, use the commands “store TN...” and the following:

NOTE: The Ethernet sessions can be configured either by a web browser or by telnet.

1.Use cmd WRKCTLD *VWS, choice 5, display, enter to list the number of virtual devices this controller.

2.Use cmd DSPSYSVAL QAUTOVRT. Note the number of auto- configured virtual devices permitted on the system. This number must be greater than one.

3.Use cmd DSPYSYVAL QCHRID. This is the system language (code page) available.

4.Use cmd WRKTCPSTS *IFC to determine the IP address of the iSeries. This value is used in setting the Ethernet TN5250 devices.

302