Chapter 2 Configuration Tools

n.Wait for “ETHERNET IS READY” to display.

o.Press RETURN + ENTER to lock the printer menu.

7.Put the printer online and wait for the “ETHERNET IS READY” message to display on the front panel. Placing the printer online starts the Ethernet Interface IP Address and Netmask update process. This process will take several minutes.

NOTE: If you do not put the printer online, the setting you just entered will not take effect. Do not turn the printer off until you see the “ETHERNET IS READY” message. If you turn the printer off before the new values are written to memory in the Ethernet Interface adapter, you will need to repower the printer and repeat steps 6 and 7 above immediately.

8.Once the “ETHERNET IS READY” message displays, you may enter the Gateway Address by repeating front panel steps 6 and 7 above. This will ensure the correct Netmask becomes associated with the Gateway value you enter. From the front panel navigate to the Gateway Address and enter the appropriate value. You must press ENTER after inputting each segment of the Gateway Address.

9.Put the printer online and wait for the “ETHERNET IS READY” message to display on the front panel.

10.Enable the Power Saver mode if desired.

56

Page 56
Image 56
IBM 6500 manual Configuration Tools