Configuration Using The Control Panel

CAUTION Turning off the printer before the firmware update is complete may permanently damage the Ethernet Interface adapter.

Updating the printer firmware takes time. Please be patient and wait for the “ETHERNET IS READY” message to display on the LCD. Do not turn off the printer before it has completed the firmware download procedure. The LCD will display “ONLINE / ETHERNET IS READY” when the download is complete. Wait for this message before turning off the printer.

6.To enter IP Address parameters, do the following:

a.Press STOP to get to the NOT READY state.

b.Press RETURN + ENTER to unlock the printer menu.

c.Press Menu to display OPERATOR MENU.

d.Press Scroll/Micro until NETWORK SETUP displays, then press Enter.

e.Press Scroll/Micro until ADAPTER ADDRESS or ETHERNET ADDRESS displays, then press Enter.

f.Press Scroll/Micro until IP ADDRESS displays, then press Enter.

g.Press Enter again, then Scroll/Micro to choose an IP address octet to change. Press Enter.

h.Press Scroll/Micro to choose the desired value for the octet, then press Enter. The new value is shown with an asterisk. Press Return.

i.Repeat steps d and e until you have set all IP address octets to the desired value.

j.Press Return until ADAPTER ADDRESS or ETHERNET ADDRESS is on the first display line.

k.Press Scroll/Micro to choose other IP parameters to change, then follow the above steps for each of these.

l.When finished, press Return multiple times until NOT READY displays.

m.Press Start.

55

Page 55
Image 55
IBM 6500 manual