![](/images/new-backgrounds/1316709/31670931x1.webp)
Assembly
To assemble your dust collector:
1.Place the base upside down on a clean, flat surface (to avoid scratching the paint).
2.Attach the casters to the base with (16) 5⁄16"- 18 x 1⁄2" flange bolts, as shown in Figure 9.
x 16
Figure 9. Caster installed onto the base.
3.Turn the base over, align the motor and impeller assembly with the mounting holes, then secure the assembly with (4) 5⁄16"-18 x 1⁄2" flange bolts, as shown in Figure 10.
BdidgVcY>beZaaZg6hhZbWan |
x 4 |
7VhZEaViZ |
Figure 10. Motor and impeller assembly installed
onto the base.
4.Place a rubber gasket around the impeller outlet rim, as shown in Figure 11.
Gasket![](/images/new-backgrounds/1316709/31670931xi3.webp)
Figure 11. Positioning impeller outlet gasket.
5.Secure the metal "Y" outlet to the impeller outlet with (8) 5⁄16"-18 x 1⁄2" flange bolts, as shown in Figure 12.
x 8
"Y" Outlet
Figure 12. Outlet connector installed.
Model G0562Z/ZP, G1030Z2/Z2P (Mfg. 11/11+) |