Woodstock W1687 instruction manual Component Layout

Page 12

Component Layout

ASSEMBLY

Figure 6. Model W1687 components laid out for identification.

The following is a description of the components shipped with the Shop Fox® Model W1687 Dust Collector. We recommend that all parts be laid out in a similar fashion to those in Figure 7. This will help in identification before beginning assembly. Should any part appear to be missing, examine the packaging carefully. If any key parts are missing call Woodstock International, Inc. at 360-734-3482 or contact us via tech-support@woodstockint.com.

• Impeller/Motor Assembly	• Upper Support Bracket (2)
• Base	• Outlet
• Collectors (2)	• Bolt 5⁄16" - 18 x 1⁄2" (52)
• 4-Way Inlet	• Bag Clamp Attachment Kit
• Collection/Filter Bags (4)	• Bag Clamps (4)
• Lower Support Brackets (2)	• Bolt 1⁄4" - 20 x 21⁄2"(4)
• Casters (4)	• Nut (4)
• Rubber Gaskets (3)	• Open-End Wrench 10/12MM
	• Allen Wrench 5MM

-10-

Image 12

Contents HP Dust Collector Page Table of Contents Woodstock Service And Support IntroductionAbout Your New Dust Collector Warranty And Returns Machine SpecificationsSafety Standard Safety InstructionsKeep proper footing and balance at all times Additional Safety Instructions For Dust Collector HP Dust CollectorAvoiding Potential Injuries Never collect anything except wood dustElectrical Requirements 220V OperationExtension Cords GroundingAssembly Instructions UnpackingComponent Layout Clean Up General BaseImpeller/Motor Assembly Outlet DuctCollectors Support BracketsCollection Bags Securing the upper bag threaded Band clampWay Inlet Fitting Securing the 4-way inlet fittingWire inside and around pipe System GroundingAccessories Material SelectionSystem Design Bird’s eye view of layoutAdjusting Outlet OperationsTest Run Maintenance CleaningLubrication Bag Cleaning Wear a respirator when Changing the bagsClosure Wiring Diagram 220V Power SourcePage Ring Gasket Warranty Card Woodstock INTERNATIONAL, INC