Woodstock W1687 instruction manual General, Base

Page 14

ASSEMBLY

General

While the main components of the Shop Fox® Model W1687 are assembled at the factory, some assembly is required. The following is the recommended sequence best suited for final assembly.

TOOLS REQUIRED: You will need a 12mm open end wrench and a Phillips head screwdriver.

Base

Position the base upside down to reveal the caster mounting brackets. Attach each of the (4) casters to the caster mounting brackets using (16) 5/16"-18 x 1/2" hex bolts as shown in Figure 8.

Safety glasses must be worn to prevent serious personal injury!

Keep loose clothing rolled up and out of the way of machinery and keep hair pulled back.

Make sure that your

machine remains unplugged during any assembly, adjustment or maintenance procedures. Ignoring this warning may result in serious personal injury!

Figure 8. Mounting the casters to the base.

-12-

Page 13 Page 15
Image 14
Page 13 Page 15
Contents HP Dust Collector Page Table of Contents About Your New Dust Collector Woodstock Service And SupportIntroduction Warranty And Returns Machine SpecificationsSafety Standard Safety InstructionsKeep proper footing and balance at all times Additional Safety Instructions For Dust Collector HP Dust CollectorAvoiding Potential Injuries Never collect anything except wood dustExtension Cords Electrical Requirements220V Operation GroundingAssembly Instructions UnpackingComponent Layout Clean Up General BaseImpeller/Motor Assembly Outlet DuctCollectors Support BracketsCollection Bags Securing the upper bag threaded Band clampWay Inlet Fitting Securing the 4-way inlet fittingWire inside and around pipe System GroundingAccessories Material SelectionSystem Design Bird’s eye view of layoutTest Run Adjusting OutletOperations Lubrication MaintenanceCleaning Bag Cleaning Wear a respirator when Changing the bagsClosure Wiring Diagram 220V Power SourcePage Ring Gasket Warranty Card Woodstock INTERNATIONAL, INC
Top Page Image Contents