MVH-200GH — ENGINE COMPONENTS
Figure 4. Engine Controls and Components
The engine shown above is a HONDA GX240K1SMX2 engine 6. Choke Lever – Used in the starting of a cold engine, or in
(Figure 4). The engine must be checked for proper lubrication cold weather conditions.The choke enriches the fuel mixture. and filled with fuel prior to operation. Refer to the manufacturers 7. Air Cleaner – Prevents dirt and other debris from entering
engine manual for instructions & details of operation and | the fuel system. Remove |
servicing. | to gain access to filter element. |
1. Fuel Filler Cap – Remove this cap to add unleaded gasoline to the fuel tank.Make sure cap is tightened securely.DO NOT over fill.
CAUTION - Fueling The Engine
Adding fuel to the tank should be done only when the engine is stopped and has had an opportunity to cool down. In the event of a fuel spill, DO NOT attempt to start the engine until the fuel residue has been completely wiped up, and the area surrounding the engine is dry.
2. Throttle Lever – Used to adjust engine RPM speed (lever advanced forward SLOW, lever back toward operator FAST).
3. Engine ON/OFF Switch – ON position permits engine starting, OFF position stops engine operations.
4. Recoil Starter (pull rope) –
5. FuelValve Lever – OPEN to let fuel flow, CLOSE to stop the flow of fuel.
Operating the engine without
NOTEan air filter, with a damaged air filter, or a filter in need of
replacement will allow dirt to enter the engine, causing rapid engine wear.
8. Spark Plug – Provides spark to the ignition system. Set spark plug gap to 0.6 - 0.7 mm (0.028 - 0.031 inch) Clean spark plug once a week.
9. Muffler – Used to reduce noise and emissions.
CAUTION - Burn Hazard
Enginecomponentscangenerateextremeheat. To prevent burns, DO NOT touch these areas while the engine is running or immediately after operating. NEVER operate the engine with the muffler removed.
10. Fuel Tank – Holds unleaded gasoline. For additional information refer to engine owner's manual.