Multiquip manual MVH-200GH START-UP Procedures, Starting the Engine Honda engine

MVH-200GH — START-UP PROCEDURES

This section is intended to assist the operator with the initial	4. Placethechoke lever(Figure10)in the"CLOSED"position
start-upof the compactor. It is extremely important that this	if starting a warm engine or the temperature is warm.
section be read carefully before attempting to use the compactor
in the field.

Starting the Engine (Honda engine):

1.Place the engine fuel valve lever (Figure 7) to the "ON" position.

Figure 10. Engine Choke Lever (Closed)

Figure 7. Engine Fuel Valve Lever (ON Position)

2.Move the throttle lever to the START position by opening it to about 20 degrees (Figure 8).

5.Place the engine ON/OFF switch (Figure 11) in the "ON " position.

Figure 11. Engine ON/OFF Switch (ON Position)

Figure 8. Throttle Lever (Start Position)

3.Place the choke lever (Figure 9) in the "OPEN " position if starting a cold engine.

6.Grasp the starter grip (Figure 12) and slowly pull it out.The resistance becomes the hardest at a certain position, corre- sponding to the compression point. Pull the starter grip briskly and smoothly for starting.

Figure 12. Starter Grip

Figure 9. Engine Choke Lever (Open)

MVH-200GH PLATE COMPACTOR — OPERATION & PARTS MANUAL — REV. #2 (09/22/06) — PAGE 17