SECTION 6: SERVICE
Review the troubleshooting and procedures in this section if a problem develops with your machine. If you need replacement parts or additional help with a procedure, call our Technical Support at (570)
Troubleshooting
Symptom | Possible Cause | Possible Solution | ||
Slip roll creates | 1. | Rollers are not parallel. | 1. | Adjust rear roller adjustment knobs as necessary to |
cones when trying |
|
|
| be sure the rear roller and top roller are parallel. |
to create cylinders. |
|
|
|
|
|
|
|
|
|
A noticeable crease | 1. | Excessive pressure applied in one spot. | 1. | Reduce the radius and perform the bend in several |
is formed in the |
|
|
| passes. |
workpiece. |
|
|
|
|
|
|
|
|
|
Crank does not | 1. | Bottom roller adjustment screws not | 1. | Engage bottom roller adjustment screws. |
turn top and bottom |
| engaged. |
|
|
rollers. | 2. | Gears are damaged. | 2. | Check/replace gears. |
|
|
|
|
|
Slip roll does not | 1. | Machine capacities exceeded. | 1. | Use materials within the capacity of the slip roll. |
bend material. | 2. | Rear roller not engaged. | 2. | Check/adjust rear roller. |
|
|
|
|
|
Model T25688 (Mfg. Since 09/13) |