ASSEMBLING CUTTERHEAD GUARD
1.Thread the two 7/16" long socket button head screws (A) Fig. 13, into the two threaded holes in front side of jointer base. DO NOT COMPLETELY TIGHTEN
SCREWS (A) AT THIS TIME.
2.Assemble guard mounting bracket (B) Fig. 14, to the two screws (A) as shown, and tighten the two screws (A).
ASSEMBLING
CUTTERHEAD LOCK
1.Assemble cutterhead lock (A) Fig. 15, to the front side of the jointer base, using the 7/16" long socket button head screw (B). NOTE: THE CUTTERHEAD
LOCK (A) IS TO BE ENGAGED WITH THE CUTTERHEAD SHAFT AS SHOWN IN FIG. 15. ONLY WHEN SETTING KNIVES. ALL OTHER TIMES THE CUTTERHEAD LOCK (A) SHOULD BE DISENGAGED FROM THE CUTTERHEAD, AS SHOWN IN FIG. 16.
A
Fig. 13
AA
B
Fig. 14
A 
B
Fig. 15
A
Fig. 16
10