Delta 37-070 instruction manual Maintenance, Belt Replacement

Page 18

MAINTENANCE

BELT REPLACEMENT

When it becomes necessary to replace the belt on your jointer, proceed as follows:

1.DISCONNECT THE TOOL FROM THE POWER SOURCE.

2.Remove screw (A) Fig. 43, using Allen wrench supplied, and remove belt guard (B).

3.Loosen three screws (C) Fig. 44, to release belt tension and remove belt (D) from pulleys.

4.Assemble new belt to the cutterhead and motor pulleys. Press down on motor pulley (E) Fig. 44, to tension belt and tighten three screws (C).

5.Replace belt guard (B) Fig. 44.

B

A

Fig. 43

B

C

D

C

CE

Fig. 44

18

Image 18

Contents Variable Speed Bench Jointer Safety Rules Always Wear EYE ProtectionAdditional Safety Rules for Jointers Connecting Tool to Power Source Power ConnectionsUnpacking and Cleaning Extension CordsDefinitions Jointing and Planing Operations Page Assembly Instructions Assembling FencePage Assembling Cutterhead Guard Assembling Cutterhead LockFastening Jointer to Supporting Surface Operating Controls and AdjustmentsLocking Switch OFF Position Starting Stopping JointerFence Adjustments Speed Control ChartDepth CUT Adjustment Variable Speed ControlPage Adjusting Knives SET TOO LOWChip and Dust Chute Cord StorageJointing AN Edge Placement of Hands During FeedingOperation Push BlocksPlaning Warped Pieces Planing Short Or Thin WorkDirection of Grain Maintenance Belt ReplacementAccessories PARTS, Service or Warranty AssistancePage Maryland