Delta 37-070 instruction manual

Page 9

3.Assemble 5/8" long socket button head screw (G) Fig. 9, to fence tilting bracket (H) and thread T-nut (J) onto threaded end of screw (G) as shown. DO NOT

COMPLETELY TIGHTEN SCREW (G) AT THIS TIME. Assemble screw and T-nut to opposite end of tilting bracket in the same manner.

4.Slide groove of fence (L) Fig. 10, over T-nuts (J) as shown.

5.Position fence (L) Fig. 11, so that rounded section

(M) on bottom of fence is over cutterhead opening as shown.

6. Tighten two screws (G) Fig. 12.

H

J

G

Fig. 9

L

J

Fig. 10

L

M

Fig. 11

GG

Fig. 12

9

Image 9

Contents Variable Speed Bench Jointer Always Wear EYE Protection Safety RulesAdditional Safety Rules for Jointers Power Connections Connecting Tool to Power SourceExtension Cords Unpacking and CleaningDefinitions Jointing and Planing Operations Page Assembling Fence Assembly InstructionsPage Assembling Cutterhead Lock Assembling Cutterhead GuardLocking Switch OFF Position Operating Controls and AdjustmentsFastening Jointer to Supporting Surface Starting Stopping JointerDepth CUT Adjustment Speed Control ChartFence Adjustments Variable Speed ControlPage SET TOO LOW Adjusting KnivesCord Storage Chip and Dust ChuteOperation Placement of Hands During FeedingJointing AN Edge Push BlocksPlaning Warped Pieces Planing Short Or Thin WorkDirection of Grain Belt Replacement MaintenancePARTS, Service or Warranty Assistance AccessoriesPage Maryland