8.If the knives are set too high, the work will be gouged at the end of the cut, as shown in Fig. 33.
9.As a final check, run a piece of work slowly over the knives for 6 to 8 inches. The wood should rest firmly on both tables as shown in Fig. 34, with no open spaces under the finished cut.
CHIP AND DUST CHUTE
A chip and dust chute (A) Fig. 35, is provided on the outfeed end of the jointer base for efficient chip removal.
CAUTION: KEEP HANDS OUT OF CHIP AND DUST CHUTE AT ALL TIMES.
| MATERIAL |
TABLE |
|
KNIVESCUTTER
SET TOO HIGH
GOUGE
Fig. 33
| MATERIAL |
TABLE |
|
KNIVES AT | CUTTER |
CORRECT HEIGHT |
|
|
|
| Fig. 34 |
A
Fig. 35
CORD STORAGE
A cord storage bracket (A) Fig. 36, is provided on jointer base for storage of the cord when machine is not in use.
A
Fig. 36
15