SECTION 7: MAINTENANCE
Disconnect power to the machine when perform- ing any maintenance, assembly or adjust- ments. Failure to do this may result in serious personal injury.
Keep loose clothing rolled up and out of the way of machinery and keep hair pulled back.
Wear safety glasses dur- ing the entire mainte- nance process. Failure to comply may result in serious personal injury.
General
Regular periodic maintenance on your Model G1182 Jointer will ensure its optimum perfor- mance. Make a habit of inspecting your jointer each time you use it. Check for the following con- ditions and repair or replace when necessary.
1.Loose mounting bolts.
2.Worn switch.
3.Worn or damaged cords and plugs.
4.Damaged
5.Any other condition that could hamper the safe operation of this machine.
Tables
The table and other
Some woodworkers recommend using automo- tive paste wax on exposed steel and cast iron surfaces. The wax provides a layer of protection, as well as reducing friction between lumber and the table, making cuts faster and smoother. Avoid waxes that contain silicone or other synthetic ingredients. These materials can find their way into lumber that’s being worked, and can make staining and finishing difficult. If you use paste wax, make sure that it’s 100% Carnauba wax.
Lubrication
Since all bearings are shielded and permanently lubricated, simply leave them alone until they need to be replaced. Do not lubricate them.
Table ways and the fence assembly should not be lubricated. If the tables appear to be stuck, dis- assemble and clean any foreign materials from the ways.
V-Belt
Inspect regularly for tension and wear; replace when necessary with a size
G1182 6" Series Jointers |