Grizzly G0725 Edge Jointing, To surface plane on the jointer,  GZVY VcY jcYZghiVcY SAFETY#

To surface plane on the jointer:

1. GZVY VcY jcYZghiVcY SECTION 1: SAFETY#

2. BV`Z hjgZ ndj ^cheZXi ndjg ldg`e^ZXZ [dg YVc\Zgdjh XdcY^i^dch Vh YZhXg^WZY ^c i]Z Choosing and Jointing Stock dcPage 26#

3. HZii]ZXjii^c\YZei][dgndjgdeZgVi^dc#LZ hj\\Zhi&¿('[dghjg[VXZeaVc^c\#

4. BV`ZhjgZndjg[ZcXZ^hhZiid.%ß#

5. >[ndjgldg`e^ZXZ^hXjeeZYlVgeZY!eaVXZ i]Z XdcXVkZ h^YZ hZZ Figure 35 dc Page 27 [VXZ Ydlc dc i]Z hjg[VXZ d[ i]Z ^c[ZZY iVWaZ#

6. HiVgii]Z_d^ciZg#

Failure to use push blocks when surface planing may result in cutterhead contact with your hands, which will cause serious personal injury. Always use push blocks to protect your hands when surface planing on the jointer.

7. L^i] V ejh] WadX` ^c ZVX] ]VcY! egZhh i]Z ldg`e^ZXZ Ydlc dc i]Z ^c[ZZY iVWaZ VcY V\V^chi i]Z [ZcXZ l^i] [^gb egZhhjgZ! i]Zc [ZZY i]Z ldg`e^ZXZ dkZg i]Z XjiiZg]ZVY! Vh h]dlc^cFigure 37#

Note:If your leading hand (with push block) gets within 4" of the cutterhead, lift it up and over the cutterhead, and place the push block on the portion of the workpiece resting on the outfeed table. Now, focus your pres- sure on the outfeed end of the workpiece while feeding, and repeat the same action with your trailing hand when it gets within 4" of the cutterhead. DO NOT place either hand closer than 4" from the cutterhead! Failure to heed this warning could result in serious personal injury.

8. GZeZViStep 7jci^ai]ZZci^gZhjg[VXZ^h[aVi#

"'-"

Edge Jointing

I]ZejgedhZd[ZY\Z_d^ci^c\^hidegdYjXZV[^c" ^h]ZY![aVi"ZY\ZYhjg[VXZhZZFigure 37hj^iVWaZ [dg_d^cZgndg[^c^h]^c\#>i^hVahdVcZXZhhVgnhiZe l]ZchfjVg^c\gdj\]dglVgeZYhidX`#

NOTICE

If you are not experienced with a jointer, set the depth of cut to zero, and practice feeding the workpiece across the tables as described below. This procedure will better prepare you for the actual operation.

Figure 37#:mVbeaZe]didd[Vine^XVa_d^ci^c\

deZgVi^dc#

Figure 38#>aajhigVi^dcd[ZY\Z_d^ci^c\gZhjaih#

BdYZa<%,'*B[\#H^cXZ%.$&&