Grizzly G0500 instruction manual G1018 Table Lever Installation, Knife Setting Gauge

G1018 Table

Lever Installation

To install the table levers on the Model G1018HW:

1.Thread a table lever into the adjustment block below each table, as shown in Figure 25.

Figure 25. Installing table lever into adjustment

block.

Knife Setting Gauge

To assemble the knife setting gauge:

1.Insert the steel rod through the hole in each adjuster arm until the notches for the E-clips extend past the adjustment arms on both sides.

2.Attach the E-clips to the notches to lock adjustment arms onto the steel rod. The adjustment arms are symmetrical, so the placement is not a concern. See Figure 26.

E-Clip

Figure 26. Assembled knife setting gauge.

G0500/G1018/G1018HW 8" Jointers -21-