18
19
20
17
22
21
|
| 24 |
27 |
| |
|
|
|
23
26
25
Figure 5. Fence controls.
17.45˚L Stop Nut
18.Fence Lock
19.Fence Tilt Lock
20.45˚R Stop Bolt
21.90˚ Stop Bolt
22.90˚ Stop Tab
Figure 6. Cutterhead details.
23.Cutterhead
24.Cutterhead Knife
25.Gib Bolt
26.Gib
27.Jack Screw Access Hole
Common Terms and Definitions
Infeed Table: The infeed table is the table where the cutting operation begins. When facing the front of the jointer, it is on the
Outfeed Table: The outfeed table is the table where the cutting operation ends. When facing the front of the jointer, it is on the
Cutterhead: The cutterhead is the cylindrical assembly that holds each of the jointer knives. It spins on a horizontal axis between the infeed and outfeed table, and is covered by the cut- terhead guard.
Fence: The jointer fence is the adjustable cast iron surface that the wood stock runs along when jointing and surface planing. The fence is adjustable from
Adjustment Levers and Handwheels: Controls the height of the infeed and outfeed tables.
Table Lock Handles: The threaded handles that must be loosened before the height of the tables can be adjusted. They are then tight- ened after the height is properly set.
Rabbet Cut: A rabbet cut is a groove cut along the long edge of the wood stock, usually used for making simple joints. The cutterhead guard must be removed for this operation, so great care is needed for safe operation.
Surface Planing: Surface planing is running the face of the wood stock over the jointer. This provides one flat side that is ready to be run through a dedicated planing machine.
Edge Jointing: Edge jointing is running the long edge of the wood stock over the jointer. This provides one flat edge that is ready to be run against the table saw rip fence or edge glued.
Cutterhead Guard: The metal guard that covers the cutterhead and automatically moves out of the way during operation, then automatically moves back into place after the operation.
G0500/G1018/G1018HW 8" Jointers |