ASSEMBLY
ASSEMBLE THE INSERTS
See Figure 5
9. Three of the inserts are for use with a specific size bit.
M
N
P
L
Fig. 5
TO ATTACH THE FENCE
See Figure 6
10.Attach the safety shield (A) to the fence (B) with 2 pan head screws (AH). Use a #3 Phillips screwdriver to tighten the screws.
AH (2)
A
B
AH
See Figure 7
11.Place the 2 washers (AE) on top of the 2 holes in the fence, insert the 2 knob screws (T) into the holes and fasten on the other side with the 2 flat nuts (Z).
NOTE: Do not tighten the 2 flat nuts at this stage.
AE (2) | Z (2) |
T
AE
B
Z
Fig. 7
See Figure 8
12.Place the fence on the tabletop so that the 2 flat nuts
(Z)are placed into the 2 slots in the table. Slide the fence forward (always parallel with the front of the table). When the fence is in the desired location tighten the knob screws (T) by turning clockwise.
T
T
Fig. 6 | Fig. 8 |
12