MOUNTING THE ROUTER
See Figure 18
8. Place clamp (R), swivel piece (Q), washer (AE), and knob (S) on screw (AC) as shown. Leave assembly loose to allow clamp to be adjusted. Repeat the above procedures for the 3 remaining clamps.
AE (4)
S
AE
Q
R
AC
Fig. 18
Fig. 19
See Figure 19
9.Position all 4 clamps on the adapter plate and tighten securely with the 4 knobs.
10.Place the router table on its legs.
NOTE: Use a minimum of 3 clamps to secure the router to the table.
NOTE: Routers larger than 2Hp should be mounted direct- ly to the table top with mounting screws as described on page 15.
NOTE: To remove the router when using the universal clamping system, it may be necessary to disassemble one or more of the clamps that secure the router to the table top.
17