Ryobi RT501W manual To Attach the Featherboards, Assemble the Miter Guide

Page 13

ASSEMBLY

TO ATTACH THE FEATHERBOARDS

See Figure 9

13.Insert the hex head screw (AJ) into the sliding block

(J).Place the sliding block into the slot of the feather- board (H). Secure by placing washer (AE) over the hex head screw (AJ). Screw together by turning the knob

(S)clockwise. NOTE: Do not completely tighten at this stage. Repeat the above for the remaining 2 feather- boards.

ASSEMBLE THE MITER GUIDE

See Figure 11

15.Place the miter guide head (E) on top of the miter bar

(X). Now fasten together by screwing the self tapping screw (AF) into the miter guide head. Assemble miter guide by threading carriage bolt (AA) through miter bar

(X). Place washer (AE) and knob (S) on end of carriage bolt. Tighten knob and then attach miter pointer (W) to rear of miter bar (X) with self tapping screw (AF).

AJ (3)

AE (3)

AA (1)

S

AE

H

J

AJ

Fig. 9

See Figure 10

14.Position 2 of the featherboards on the fence and secure by turning the knobs (S) clockwise. Place the third featherboard into the slot provided on the table- top and tighten in the same way.

S

S

Fig. 10

AE (1)

AF (2)

S

AF

AE

W

E

X

AA

AF

Fig. 11

WARNING:

Before mounting the router make sure you have read and understood pages 10-13 of your owner’s manual.

13

Image 13

Contents Save this Manual for Future Reference OPERATOR’S ManualIntroduction Table of ContentsRules for Safe Operation Unpacking and Checking Contents Router Table features include Features and SpecificationsItem Description QTY Package Contents and Hardware LegendQTY DescriptionPackage Contents and Hardware Legend Package Contents and Hardware Legend Assembling the Router Table AssemblyTo attach screws, washers and nuts for mounting router To Attach the Switch BOXTo Attach the Fence Assemble the InsertsAssemble the Miter Guide To Attach the FeatherboardsMounting Routers with Round Adapter Base Plate Mounting the RouterAM/AN Hole patternRouter base plate or 10-32 X 1/2 pan Head screw III. Mounting Routers with the universal clamping system Mounting the Router Introduction Switch BOXElectrical Hookup Operation of Switch Box and Router Switch Box FamiliarizationFor Routers With LOCK-ON Feature Circuit BreakerAssemble and using the Inserts Connecting a VacuumOperation Insert UseUsing your router/router table Using fencePencil line #1 Routing without safety shield, and/or fence Using the router for beading and edge cuttingInside routing Outside routing Using adjustable fencesUsing miter guide AccessoriesUsing featherboards Securing the Router TableRepair Parts Repair parts tabletop Key No Repair parts fence Key NoHardware bag 119800219 Hardware bag 119800226Page Service Model no