Ryobi RT501W manual Using fence, Using your router/router table, Pencil line #1

Page 21

OPERATION

Using fence

See Figure 26

To position the fence on tabletop, make this adjustment.

1.Place the fence on the tabletop.

2.Loosen the 2 knobs (T).

3.Slide the fence into the required position.

NOTE: Fence should always be parallel with the frontside of the table.

4. Tighten the knobs (T) by turning clockwise.

Using your router/router table

WARNING:

Before you start work with your new router table: Refer to your router owner's manual to see how the height of the cut can be adjusted.

WARNING:

Make sure router is unplugged before starting depth/height adjustments.

Adustable

T fence

Fence

T

Adustable

fence

Fig. 26

CAUTION:

Make sure that the 4 knobs (connected to the 2 adjustable fences) are securely tightened.

NOTE: Using scrap board that is smooth and true is recommended for making this adjustment.

See Figure 27

1.At the end of the board, use a soft pencil to mark line #1. This indicates the depth of the cut.

2.Then mark line #2, indicating the height of the cut.

3.Place your board so that it is snug against the fence face. The end with lines #1 and #2 should be near the bit.

4.Loosen fence clamping knobs enough so you can move the fence easily. Move fence and board so that the board contacts the outer edge of the router bit at line #1.

5.Tighten fence clamping knobs.

6.Adjust router height so the cutting edge of the bit contacts line #2.

7.Make sure bit is securely tightened in the collet.

Pencil line #1

Pencil line #2

Fig. 27

21

Image 21
Contents Save this Manual for Future Reference OPERATOR’S ManualIntroduction Table of ContentsRules for Safe Operation Unpacking and Checking Contents Router Table features include Features and SpecificationsItem Description QTY Package Contents and Hardware LegendQTY DescriptionPackage Contents and Hardware Legend Package Contents and Hardware Legend Assembling the Router Table AssemblyTo attach screws, washers and nuts for mounting router To Attach the Switch BOXTo Attach the Fence Assemble the InsertsAssemble the Miter Guide To Attach the FeatherboardsMounting Routers with Round Adapter Base Plate Mounting the RouterAM/AN Hole patternRouter base plate or 10-32 X 1/2 pan Head screw III. Mounting Routers with the universal clamping system Mounting the Router Switch BOX IntroductionElectrical Hookup Operation of Switch Box and Router Switch Box FamiliarizationFor Routers With LOCK-ON Feature Circuit BreakerAssemble and using the Inserts Connecting a VacuumOperation Insert UseUsing fence Using your router/router tablePencil line #1 Using the router for beading and edge cutting Routing without safety shield, and/or fenceInside routing Outside routing Using adjustable fencesUsing miter guide AccessoriesUsing featherboards Securing the Router TableRepair Parts Repair parts tabletop Key No Repair parts fence Key NoHardware bag 119800219 Hardware bag 119800226Page Service Model no