Ryobi RT501W manual Router base plate or 10-32 X 1/2 pan Head screw

Page 15

MOUNTING THE ROUTER

See Figure 13

6.Mount the router with adaptor base plate by putting the pan head screws (AG) through the holes in the tabletop and fasten to the nuts in the adapter plate (F) at posi- tion H. (The adapter plate comes from the factory with the mounting nuts pressed into it.) Tighten securely.

CAUTION:

Make sure the screws from router base plate are long enough to mount router securely. Replace if necessary.

AG (3)

AG

II.Mounting Routers with Three-Hole Base Plate (Hole Pattern "E")

Note: Refer to Hole Pattern Chart on page 14 to deter- mine the correct hole pattern for your router.

See Figure 14

1.Remove router base plate from router by removing screws.

2.While holding router upside down, position it to the underside within the center ring of the table top.

3.Rotate router until the three mounting holes in router base line up with the three larger holes in the table top.

4.Insert three machine screws from router base plate through holes in tabletop and into router mounting holes. Tighten securely.

5.To mount Craftsman routers that use the E-hole pattern to the table top, use three 10 - 32 x 1/2" pan head screws (not provided).

NOTE: For ease of use, position the router so the ON-OFF switch is accessible from the front of the table.

CAUTION:

Make sure the screws from router base plate are long enough to mount router securely. Replace if necessary.

NOTE: Screw from

router base plate or 10-32 X 1/2" pan

head screw.

Fig. 13

Fig. 14

15

Page 14 Page 16
Image 15
Page 14 Page 16
Contents Save this Manual for Future Reference OPERATOR’S ManualIntroduction Table of ContentsRules for Safe Operation Unpacking and Checking Contents Router Table features include Features and SpecificationsItem Description QTY Package Contents and Hardware LegendQTY DescriptionPackage Contents and Hardware Legend Package Contents and Hardware Legend Assembling the Router Table AssemblyTo attach screws, washers and nuts for mounting router To Attach the Switch BOXTo Attach the Fence Assemble the InsertsAssemble the Miter Guide To Attach the FeatherboardsHole pattern Mounting the RouterMounting Routers with Round Adapter Base Plate AM/ANRouter base plate or 10-32 X 1/2 pan Head screw III. Mounting Routers with the universal clamping system Mounting the Router Switch BOX IntroductionElectrical Hookup Circuit Breaker Switch Box FamiliarizationOperation of Switch Box and Router For Routers With LOCK-ON FeatureInsert Use Connecting a VacuumAssemble and using the Inserts OperationUsing fence Using your router/router tablePencil line #1 Using the router for beading and edge cutting Routing without safety shield, and/or fenceInside routing Outside routing Using adjustable fencesSecuring the Router Table AccessoriesUsing miter guide Using featherboardsRepair Parts Hardware bag 119800226 Repair parts fence Key NoRepair parts tabletop Key No Hardware bag 119800219Page Service Model no
Top Page Image Contents