OPERATION
WARNING:
If the collet nut is not securely tightened, the bit may detach during use, causing serious personal injury.
WARNING:
Never use bits which are larger in diameter than the open- ing in the router subbase. These situations could cause possible loss of control or create other hazardous condi- tions that could cause possible serious personal injury.
CAUTION:
To prevent damage to the spindle or spindle lock, always allow motor to come to a complete stop before engaging the spindle lock.
WARNING:
If you are changing a bit immediately after use, be careful not to touch the collet nut, bit, or collet with your hands or fingers. You will get burned because of the heat buildup from cutting. Always use the wrench provided.
WARNING:
Bit continues to rotate after the router has been turned off. To avoid injury, wait until the bit has come to a complete stop before removing router from the workpiece.
installing/REMOVING bits
See Figure 3.
nUnplug the router.
To install the bit:
nPush the spindle lock down and in, holding it into place.
nLoosen the collet nut and remove the bit.
nInsert the bit until it is approximately 1/8 in. to 1/4 in. away from the collet nut face.
NOTE: Make sure that the collet always clamps the shank
nTighten the collet nut securely by turning it clockwise with the wrench provided.
nRelease the spindle lock.
To remove the bit:
nPush the spindle lock down and in, holding it into place.
nLoosen the collet nut and remove the bit.
nRelease the spindle lock.
COLLET NUT
TO
LOOSEN
TO
TIGHTEN
SPINDLE
LOCK
Fig. 3
LED
WORKLIGHT
Fig. 4
LED WORKLIGHT
See Figure 4.
The two LED worklights on the base of the router motor will come on when the ON/OFF switch is in the ON ( I ) position. This provides additional lighting on the surface of the workpiece for operation in
11