OPERATION
Note: To adjust the depth of cut when the router is mounted to a router table, unplug the router, loosen the lock lever, turn the depth adjustment knob until the bit reaches the desired depth of cut, and retighten the lock lever.
When the router is mounted to a router table, depth adjust- ments can be made easily by using a
To make through table adjustments:
nUnplug the router.
nLoosen the lock lever.
nInsert a
nTurn the wrench counterclockwise to move the collet down or clockwise to move the collet up.
Note: It should not be possible to make depth adjustments with the lock lever tightened. If depth adjustments are possible with the lock lever tightened, an adjustment to the lock lever needs to be made. See Adjustments.
nWhen the desired depth of cut is set, tighten the lock lever.
WARNING:
Do not use with router tables that fail to conform to safe woodworking practices and offer proper guarding for the bit. Use router tables that are UL classified and identified suitable for use with the specific router model. Failure to comply can result in an accident causing possible injury.
WARNING:
Only use router tables with proper guarding for the bit and with
Turning the router on and off
See Figure 7.
To turn the router on, push the switch to the ( I ), or ON position. Return the switch to the ( O ), or OFF position when routing operation is finished.
ON/OFF
SWITCH
Fig. 7
13