Ryobi R163K manual Service Model NO. and Serial no

Page 20

OPERATOR’S MANUAL

FIXED BASE ROUTER

DOUBLE INSULATED

R163

WARNING:

Some dust created by power sanding, sawing, grinding, drilling, and other construction activities con- tains chemicals known to cause cancer, birth defects or other reproductive harm. Some examples of these chemicals are:

lead from lead-based paints,

crystalline silica from bricks and cement and other masonry products, and

arsenic and chromium from chemically-treated lumber.

Your risk from these exposures varies, depending on how often you do this type of work. To reduce your exposure to these chemicals: work in a well ventilated area, and work with approved safety equipment, such as those dust masks that are specially designed to filter out microscopic particles.

• SERVICE

Now that you have purchased your tool, should a need ever exist for repair parts or service, simply contact your nearest Authorized Service Center. Be sure to provide all pertinent facts when you call or visit. Please call 1-800-525-2579 for your nearest Authorized Service Center. You can also check our web site at www.ryobitools.com for a complete list of Authorized Service Centers.

• MODEL NO. AND SERIAL NO.

The model number of this tool will be found on a plate attached to the motor housing. Please record the model number and serial number in the space provided below.

• HOW TO ORDER REPAIR PARTS

When ordering repair parts, always give the following information:

MODEL NUMBER

R163

SERIAL NUMBER

 

Ryobi® is a registered trademark of Ryobi Limited used under license.

ONE WORLD TECHNOLOGIES, INC.

 

1428 Pearman Dairy Road, Anderson, SC 29625

 

Phone 1-800-525-2579

983000-958

www.ryobitools.com

 

06-18-07 (REV:01)

20

 

Image 20
Contents OPERATOR’S Manual Save this Manual for Future ReferenceTable of Contents IntroductionGeneral Safety Rules Work Area SafetyElectrical Safety Personal SafetySpecific Safety Rules ServiceSymbols Name DESIGNATION/EXPLANATIONService Symbol Signal MeaningCord Length Wire Size A.W.G ElectricalDouble Insulation Electrical ConnectionFeatures Product SpecificationsON/OFF Switch Chip ShieldAssembly REMOVING/INSTALLING Router Base AdjustmentsOperation ApplicationsInstalling/REMOVING bits To install the bitLED Worklight To remove the bitSee Figures 5 SETting Depth of CUTSelectING Depth of CUT To make through table adjustments Turning the router on and offOperating the router Internal routingEdge routing Straight Edge Clamp WorkpieceFreehand routing Edging with pilot bitWork Router Pilot TOP Edge Shaping Routerguide Work Pilot Whole Edge ShapingDirection of Feed and Thrust Proper Rate of FeedSee Figures 12 Proper CuttingToo fast Too slow Feeding Too FastFeeding Too slow Adjusting Lock lever Tension Depth of CUTSee Figures 16 To TightenMaintenance AccessoriesGeneral Maintenance Cleaning the ColletService Model NO. and Serial no