Ryobi A25RT01 manual Making Insert Plate Level, Attaching the Fence Assembly

Page 14

ASSEMBLY

MAKING INSERT PLATE LEVEL

See Figure 12.

Unplug the router table and/or the router.

Check to see if the insert plate mounted assembly is level with a straight edge or level.

Using the supplied hex key, tighten or loosen the adjust- ing screws depending on how the insert plate needs to be adjusted in order to make the insert plate level.

Tighten insert plate screws with a screwdriver.

HEX KEY

INSERT

PLATEADJUSTING

STRAIGHT SCREWS EDGE

3

2

1 0

1

Inch

ATTACHING THE FENCE ASSEMBLY

See Figure 13.

 Unplug the router table and/or the router.

 Place the router table right side up with the back edge closest to you.

FEED DIRECTION

3

2

1 0

1

Inch

 Slide the carriage bolt washers onto the carriage bolts.

 Slide carriage bolts through the slot in the router table and through the slots in the fence assembly.

Slide the fence lock knob washer over the carriage bolts.

 Install the fence lock knobs over the carriage bolts.  Tighten the fence lock knobs.

WARNING:
Make sure throat plates snap securely into place. Do	SLOT
not use if snaps are damaged or throat plates do not
snap in securely. Failure to do so could result in serious
personal injury.

	Fig. 12
FENCE LOCK KNOB	FENCE LOCK KNOBS
WASHER

Inch

1

1 2 3

INSERTING AND REMOVING THROAT PLATES

See Figure 14.

The throat plate provides a stable surface around the cutter and prevents objects from falling through the throat plate and damaging the spindle.

CARRIAGE BOLT WASHER

CARRIAGE BOLTS

Inch

1

FENCE

ASSEMBLY

Fig. 13

14

Image 14

Contents OPERATOR’S Manual Save this Manual for Future ReferenceWarranty IntroductionGeneral Safety Rules Read ALL Instructions do not USE Awkward Hand Positions Specific Safety Rules Always USE the Articulating Router Cutter BIT Guard Symbols Name DESIGNATION/EXPLANATIONService Symbol Signal MeaningExtension Cords Speed and WiringElectrical Electrical ConnectionFeatures Starting PIN Reset ButtonSwitch Assembly Throat PlatesPacking List AssemblyUnpacking Attaching the Under Table Guards Attaching the Switch BOXAssembling the Router Table Attaching the Table LegsAttaching the Router to the Table PRE-DRILLING Holes for Through Table Depth AdjustmentInstalling the ROUTER/INSERT Plate Assembly Attaching the Router to the Insert PlateKM12VC Attaching the Fence Assembly Making Insert Plate LevelInserting the Starting PIN Installing the Miter GaugeInstall Remove Miter GaugeMounting the Router Table to a Work Bench Attaching the Vacuum HoseClamping the Router Table to a Work Bench Performing a Routing Operation OperationApplications INSERTING/REMOVING Cutters Adjusting Depth of CUTAdjusting the Miter Gauge Positioning the FenceMaintenance General MaintenanceParts and Service