Ryobi A25RT01 manual Attaching the Vacuum Hose, Clamping the Router Table to a Work Bench

ASSEMBLY

ATTACHING THE VACUUM HOSE

See Figure 17.

The vacuum port molded into the fence will accept either a 1-1/4 in. or 2-1/2 in. vacuum attachment.

CLAMPING THE ROUTER TABLE TO A WORK BENCH

See Figures 18.

Unplug the router table and/or the router.

Place the router table right side up on a sturdy work surface; e.g., leg stand, workbench, counter top.

Using a clamp, insert the top front of clamp through the opening in the router table leg.

Tighten clamp securely.

MOUNTING THE ROUTER TABLE TO A WORK BENCH

See Figure 19.

 Unplug the router table and/or the router.

 Place the router table right side up on a sturdy work

surface; e.g., leg stand, workbench, counter top.

 Mark the holes with a pencil.

 Remove the router table.

 Drill four holes through the work surface.

 Place the router table back on the work surface, align-

ing the holes in the table legs with the holes in the work

surface.

NOTE: Position the router table surface at approximately

hip height.

 Insert four bolts (not included, 1/4-20 recommended) and

VACUUM PORT

inch 1

	FEED
DIRECTION
inch	1

VACUUM HOSE

0

1

Inch

2

0

FEED	1
DIRECTION	Inch

Fig. 17

tighten securely with flat washers, lock washers, and hex

nuts (not included).

WORK TABLE

CLAMP

2

0

1

Inch

FEED

DIRECTION

Fig. 18

BOLTS

0

1

Inch

FLAT

WASHER

HEX NUT	LOCK	WORK TABLE
	WASHER	Fig. 19

16