Ryobi A25RT01 manual Parts and Service

Page 20

OPERATOR’S MANUAL

ROUTER TABLE

A25RT01

WARNING:

Some dust created by power sanding, sawing, grinding, drilling, and other construction activities contains chemicals known to cause cancer, birth defects or other reproductive harm. Some examples of these chemicals are:

•lead from lead-based paints,

•crystalline silica from bricks and cement and other masonry products, and

•arsenic and chromium from chemically-treated lumber.

Your risk from these exposures varies, depending on how often you do this type of work. To reduce your exposure to these chemicals: work in a well ventilated area, and work with approved safety equipment, such as those dust masks that are specially designed to filter out microscopic particles.

•PARTS AND SERVICE

Prior to requesting service or purchasing replacement parts, please obtain your model and serial number from the product data plate.

• MODEL NUMBER

A25RT01

•SERIAL NUMBER

•HOW TO OBTAIN REPLACEMENT PARTS:

Replacement parts can be purchased online at www.ryobitools.com or by calling 1-800-525-2579. Replacement parts can also be obtained at one of our Authorized Service Centers.

•HOW TO LOCATE AN AUTHORIZED SERVICE CENTER:

Authorized Service Centers can be located online at www.ryobitools.com or by calling 1-800-525-2579.

•HOW TO OBTAIN CUSTOMER OR TECHNICAL SUPPORT:

To obtain Customer or Technical Support please contact us at 1-800-525-2579.

Ryobi® is a registered trademark of Ryobi Limited used under license.

ONE WORLD TECHNOLOGIES, INC.

1428 Pearman Dairy Road, Anderson, SC 29625

Phone 1-800-525-2579

www.ryobitools.com

987000-114

03-08-07 (REV:00)

Page 19 Page 20
Image 20
Page 19 Page 20
Contents OPERATOR’S Manual Save this Manual for Future ReferenceWarranty IntroductionGeneral Safety Rules Read ALL Instructions do not USE Awkward Hand Positions Specific Safety Rules Always USE the Articulating Router Cutter BIT Guard Symbols Name DESIGNATION/EXPLANATIONService Symbol Signal MeaningSpeed and Wiring ElectricalExtension Cords Electrical ConnectionFeatures Reset Button Switch AssemblyStarting PIN Throat PlatesPacking List AssemblyUnpacking Attaching the Switch BOX Assembling the Router TableAttaching the Under Table Guards Attaching the Table LegsPRE-DRILLING Holes for Through Table Depth Adjustment Installing the ROUTER/INSERT Plate AssemblyAttaching the Router to the Table Attaching the Router to the Insert PlateKM12VC Attaching the Fence Assembly Making Insert Plate LevelInstalling the Miter Gauge Install RemoveInserting the Starting PIN Miter GaugeMounting the Router Table to a Work Bench Attaching the Vacuum HoseClamping the Router Table to a Work Bench Performing a Routing Operation OperationApplications Adjusting Depth of CUT Adjusting the Miter GaugeINSERTING/REMOVING Cutters Positioning the FenceMaintenance General MaintenanceParts and Service
Top Page Image Contents