Ryobi A25RT01 Inserting the Starting PIN, Installing the Miter Gauge, Install Remove, Pointer

Page 15

ASSEMBLY

The proper size throat plate depends on the size and shape of the cutter. When inserted, the throat plate opening should be within approximately 1/4 in. of the outermost edge of the cutter.

Unplug the router table and/or the router.

Select the throat plate you wish to use.

Press throat plate into insert plate slot until it snaps into place.

To remove, push throat plate out from the bottom of the insert plate.

THROAT PLATE

TAB

2

1 0

1

INSERTING THE STARTING PIN

 

See Figure 15.

 

Place the starting pin on the router table and use it as a pivot

 

point when cutting small, odd-shaped pieces.

NOTCH

NOTE: It is not necessary to use the fence when you are

using the starting pin, but the bit guard should be used to cover the cutter. Additionally, only use piloted cutters when using the starting pin.

Unplug the router table and/or the router.

Place the starting pin into the hole to the right of the router

1

table throat opening.

 

2

1 0

1

Fig. 14

STARTING PIN

Push the pin in to secure.

INSTALLING THE MITER GAUGE

See Figure 16.

Unplug the router table and/or the router.

With the router table right side up, and the front edge closest to you, place the miter gauge bar in the slot near the front of the table with the pointer on the right.

STARTINGPIN HOLES

INSTALL

REMOVE

0

1

Inch

Fig. 15

MITER

 

GAUGE BAR

MITER GAUGE

POINTER

FEED DIRECTION

0 1

Inch

SLOT

Fig. 16

15

Page 14 Page 16
Image 15
Page 14 Page 16
Contents Save this Manual for Future Reference OPERATOR’S ManualIntroduction WarrantyRead ALL Instructions General Safety RulesSpecific Safety Rules  Always USE the Articulating Router Cutter BIT Guard do not USE Awkward Hand Positions Name DESIGNATION/EXPLANATION SymbolsSymbol Signal Meaning ServiceElectrical Connection Speed and WiringElectrical Extension CordsFeatures Throat Plates Reset ButtonSwitch Assembly Starting PINAssembly UnpackingPacking List Attaching the Table Legs Attaching the Switch BOXAssembling the Router Table Attaching the Under Table GuardsAttaching the Router to the Insert Plate PRE-DRILLING Holes for Through Table Depth AdjustmentInstalling the ROUTER/INSERT Plate Assembly Attaching the Router to the TableKM12VC Making Insert Plate Level Attaching the Fence AssemblyMiter Gauge Installing the Miter GaugeInstall Remove Inserting the Starting PINAttaching the Vacuum Hose Clamping the Router Table to a Work BenchMounting the Router Table to a Work Bench Operation ApplicationsPerforming a Routing Operation Positioning the Fence Adjusting Depth of CUTAdjusting the Miter Gauge INSERTING/REMOVING CuttersGeneral Maintenance MaintenanceParts and Service
Top Page Image Contents