OPERATION
WARNING:
Never connect the router to power supply when you are assembling parts, making adjustments, installing or re- moving cutters, or when not in use. Disconnecting the router prevents accidental starting that could cause se- rious injury.
REMOVING AND INSTALLING THE ROUTER BASE
TO REMOVE THE ROUTER BASE
See Figure 4.
1. Unplug the router.
WARNING:
Failure to unplug the tool could result in accidental start- ing causing serious injury.
2.Place the router upside down with the Ryobi label away from you.
3.Loosen the locking arm on the base.
4.Depress and hold the gold spindle lock button. The gold spindle lock button will not depress fully unless it is in line with the hole in the collet.
5.If the gold spindle lock button does not depress fully, turn the collet nut while depressing the gold spindle lock button. As they align, the gold spindle lock button will depress fully.
6.Turn the depth adjusting ring counterclockwise until the motor is to its highest position. NOTE: As the motor is rising, the gold spindle lock button has to be depressed until it clears the rear window.
7.Align the indicator arrow on the depth adjustment ring with the indicator point on the base.
8.Pull the base until it dislodges from the motor housing.
TO INSTALL THE ROUTER BASE
1.Unplug the router.
2.Place the fixed or
3.Loosen the locking arm.
4.Align the indicator arrow on the depth adjustment ring with the indicator point on the base.
5.Align the groove in the motor housing with the tab inside of the base. NOTE: The tab is located on the inside of the base in line with the handle.
6.Depress and hold the gold spindle lock button on the motor.
7.Slide the motor housing into the base.
8.Turn the depth adjusting ring counterclockwise until the gold spindle lock snaps out as it clears the rear window, just below the locking arm.
9.Tighten the locking arm.
LOCKING
DEPTHARM ADJUSTMENT
RING
GOLD
SPINDLE LOCK
BUTTON
INDICATOR
ARROW
1/32 | 0 | 1 | 2 |
| |||
|
|
| |
DEPTH |
|
| 15/32 |
INDICATOR |
|
|
|
RING |
|
|
|
INDICATOR POINT |
|
| |
Fig. 4
11