Ryobi Comprehensive Guide to Mounting and Installing Your Router

ROUTER MOUNTING

TO MOUNT ROUTER WITH PLATE TO ACCESSORY TABLE:

■Place the router with the mounting plate under the accessory table. See Figure 11.

■Secure the mounting plate to accessory table using the four #1/4-20 x 1/2 in. flat head screws provided.

NOTE: The accessory table can be removed from the table saw to attach the router and mounting plate. Follow instructions in the table saw operator's manual for removing and reattaching the accessory table.

■Tighten screws securely.

TO INSTALL ROUTER BIT AND THROAT PLATE:

■Follow the instructions in the operator's manual of your router for this procedure. Install router bit and securely tighten in collet.

CAUTION:

Make sure the router bit will not strike the accessory table or any metal surface.

■Select the correct size throat plate for the size of the router bit. Align the tab on the throat plate with the slot in the accessory table and snap in place. Make sure the throat plate is firmly seated below the table surface. Recheck the router bit to make sure it will not strike the throat plate.

WARNING:

The router throat plates are included to assure no more than 1/4 in. (6.4 mm) clearance between the cutter and the opening in the throat plate. Use correct throat plate. Do not use a router bit smaller than 1/8 in. (3.2 mm) or larger than 2 in. (50 mm) in diameter.

TO INSTALL TABLE CLAMPING BRACKET:

The lever on the accessory table will tighten the table securely to the front rail. The weight of the router and mounting plate may cause the accessory table to loosen or have movement at the rear of the table. To avoid this, install the table clamping bracket supplied with this kit.

■Remove end plug from rear rail as shown in Figure 12.

■Slide one of the T-nuts into the front channel of the rear rail and under the accessory table.

■The table clamping bracket fits in the bottom slot of the rear rail. The slotted top of this bracket wraps

THROAT PLATE

#1/4-20 SCREWS (PROVIDED)

ACCESSORY TABLE

SLOT

ROUTER
WITH MOUNTING
PLATE ATTACHED	Fig.11
TABLE CLAMPING BRACKET
SHOWN COMPLETELY ASSEMBLED

ACCESSORY TABLE
TABLE	END PLUG
CLAMPING BRACKET

T-NUT

REAR RAIL

5/16 in. WASHER

KNOB BOLT

Fig.12

Page 11