Assembly, See Figure | Ryobi 4950301 specification

ASSEMBLY

WARNING:

The saw's motor cord must be disconnected from the receptacle on the saw when using this kit. The power cord of the router must be plugged into the receptacle on the saw. The saw's master switch must be used to turn the router ON and OFF. Failure to do so could result in serious injury.

IMPORTANT

This router kit has been specifically designed for use with Ryobi Routers. The hole pattern on the mounting plate has not been drilled to accommodate other routers.

NOTE: Mounting screws for Ryobi routers, model numbers R160, R161, R165, RE170, RE170VS, R175, RE175, R180, RE185, RE600, and RE601 are provided in this kit. Models R175 and RE180PL must also use #4830175 depth control kit, which is sold separately.

TO INSTALL T-NUTS FOR GUIDE FENCE BRACKETS:

See Figure 2.

This kit requires that five of the six special 5/16 in. T-nuts provided fit in the top channel of the rip fence on your table saw.

■Place miter fence against blade and lock in place.

■Using the appropriate allen wrench supplied with your table saw, remove the rear adjustment screw and washer on top of the rip fence.

■Slide one of the T-nuts into the top channel of rip fence and place between the two adjustment screws.

NOTE: T-nuts install from the rear of the rip fence.

■Replace the washer and the rear adjustment screw and tighten securely.

■Check the rip fence for squareness with the saw blade.

■Unlock the rip fence, slide it away from the saw blade, and lock it in place.

■Slide the four remaining T-nuts into the top channel of rip fence. See Figure 3.

NOTE: Five T-nuts should be in the top channel of the rip fence with only one of them between the adjustment screws on the rip fence.

T-NUT SHOWN BETWEEN ADJUSTMENT SCREWS

T-NUT

REAR ADJUSTMENT

SCREW

WASHER

RIP FENCE SHOWN
LOCKED AGAINST SAW BLADE	Fig. 2
	Fig. 2

INSTALL T-NUTS FROM REAR OF RIP FENCE

T-NUT

WOODEN INSERT

Fig. 3

Page 7