ROUTER MOUNTING
around the raised portion on the underside of the accessory table, clamping it tightly against the rear rail.
■Secure with a 5/16 in. washer and
■Tighten knob bolt securely.
FINAL ASSEMBLY:
After the router mounting parts have been assembled, your setup should be similar to Figure 13.
■Compare your setup and make any necessary adjustments.
■Recheck all knob bolts, attachments, etc., and securely tighten.
DIRECTION OF FEED IS FROM RIGHT TO LEFT AGAINST SHARP EDGES OF ROTATING BIT
ROUTER KIT SHOWN COMPLETELY ASSEMBLED
Fig. 13
OPERATION
FINAL PREPARATION FOR OPERATION
See Figure 13. | WARNING: |
■Adjust dust cover so that it will not come in contact with workpiece during a cutting operation.
■Direction of feed of workpiece is from right to left as shown by the arrows in figure 13.
■The workpiece must always be tight against the guide fence, unless a ball bearing piloted bit is being used. The infeed fence should be adjusted to support the uncut workpiece while the outfeed fence should be adjusted to properly support the workpiece after the cut passes the router bit, compensating for the removed stock.
The direction of feed for the workpiece is always against the sharp edges of the bit and into the rotation of the cutter. Failure to heed this warning can result in serious personal injury.
WARNING:
Do not use the guide fence with
WARNING:
The guard/dust cover must be used in all routing operations. Do not attempt freehand use on workpieces larger than 6 in. (15 cm) in diameter.
Page 12