Ryobi Router Instructions for Assembly and Setup

ASSEMBLY

TO ASSEMBLE ROUTERS WITH 4-HOLE PATTERN TO ROUTER MOUNTING PLATE:

See Figures 9 and 10.

For Ryobi routers, model numbers RE600 and RE601.

■Unplug the router.

WARNING:

Unplug the router to avoid possible injury.

■Make sure the router switch is OFF and the router is not connected to a power source.

■Place the router upside down on a workbench and remove the subbase screws and subbase from the router.

■Align mounting holes of the mounting plate with the four threaded holes in the router base.

■The switch handle of the router should be facing the squared end of the mounting plate.

See Figure 9.

■Secure the router mounting plate to the router using four M8 flat head screws provided in the router mounting kit. Tighten screws securely.

■Properly installed, the mounting plate will be securely attached to the router.

See Figure 10.

NOTE: The clearance needed for mounting a router to the table creates a gap between the accessory table and the saw table. This gap must be filled with a 22 in. wooden insert of appropriate width. This insert should be 1-1/2 in. thick. Place this wooden insert in the gap, level with the accessory table. Assure that the insert does not interfere with the rip fence. The rip fence should be positioned over the accessory table and the wooden insert, as appropriate. See Figures 2 and 3.

WARNING:

Any gap between the tables resulting from the router set up must be filled to reduce the risk of serious injury.

ROUTER WITH 4–HOLE PATTERN

ROUTER

MOUNTING

SCREWS

	ROUTER	ROUTER
		MOUNTING
	BASE
		PLATE

FRONT

OF ROUTER

Fig. 9

4–HOLE ROUTER WITH MOUNTING PLATE ATTACHED

Fig. 10

Page 10