Ryobi 4950301 manual See Figures 7

ASSEMBLY

TO ASSEMBLE ROUTERS WITH 2-HOLE PATTERN TO ROUTER MOUNTING PLATE (cont'd):

See Figures 5 and 6.

■Secure the router mounting plate to the router using two 5/16-18 x 3/4 in. bolts provided in the router mounting kit. Tighten screws securely.

■Properly installed, the mounting plate will be securely attached to the router.

See Figure 6.

TO ASSEMBLE ROUTERS WITH 3-HOLE PATTERN TO ROUTER MOUNTING PLATE:

See Figures 7 and 8.

For Ryobi routers, model numbers R160, R161, R165, RE170, RE170VS, R180, and RE185.

■Unplug the router.

WARNING:

Unplug the router to avoid possible injury.

■Make sure the router switch is OFF and the router is not connected to a power source.

■Place the router upside down on a workbench and remove the subbase screws and subbase from the router.

■Align mounting holes of the mounting plate with the three threaded holes in router base.

■The switch handle of the router should be facing the squared end of the mounting plate.

See Figure 7.

■Secure the router mounting plate to the router using three 5/16-18 x 3/4 in. bolts provided in the router mounting kit. Tighten screws securely.

■Properly installed, the mounting plate will be securely attached to the router.

See Figure 8.

2–HOLE ROUTER WITH MOUNTING PLATE ATTACHED

	Fig. 6
ROUTER	ROUTER WITH 3–HOLE PATTERN
	ROUTER
MOUNTING	MOUNTING
SCREWS	PLATE

ROUTER

BASE

FRONT

OF ROUTER

Fig. 7

3–HOLE ROUTER WITH MOUNTING PLATE ATTACHED

Fig. 8

Page 9