GENERAL
The LA and LB evaporator units are designed for use with the HA/HB Series condensing units.Units are designed to match up with LA/LB series Evaporator Blowers to meet ASHRAE 90.1 standards.
Each unit consists of a coil section and a blower section that are factory assembled and shipped as shown in figures 3 and
4.These sections may be rearranged in the field for other air discharge patterns. See figures 7, 8 and 9.
The LA and LB evaporator units have 24 volt normally closed solenoid valves to match the
NOTES, CAUTIONS AND WARNINGS
Installer should pay particular attention to the words: NOTE, CAUTION and WARNING. Notes are intended to clarify or make installation easier. Cautions are given to prevent equipment damage. Warnings are given to alert installer that personal injury and/or equipment damage may result if instal- lation procedure is not handled properly.
REPLACEMENT PARTS
Refer to parts manual for complete listing of replacement parts on this equipment. The above forms and all other forms referenced on this instruction may be ordered from;
Standard Register
2101 W. Tecumseh Road
Norman, OK 73069
Telephone : (877)
Toll Free Fax: (877)
INSPECTION
As soon as a unit is received, it should be inspected for possi- ble damage during transit. If damage is evident, the extent of the damage should be noted on the carrier's freight bill. A separate request for inspection by the carrier's agent should be made in writing.
LIMITATIONS
This unit must be installed in accordance with all national and local safety codes. If no local codes apply, installation must conform to the appropriate national code. The unit is designed to meet National Safety Code Standards. If components are to be added to a unit to meet local codes, they are to be installed at the dealer's and/or the customer's expense. See Table 1 for unit application data.
4 | Unitary Products Group |